We were curious if Atmel has finally shrunk the AVR series smaller than the current 350nm 3 metal layer process. Their main competitors (Microchip) have began showing 350nm 4 metal layer devices and Atmel has a few new product lines out (CAN, Picopower, and USB featured devices).
We chose to examine their picoPower line of AVR’s since they claim true 1.8v operation. The only picoPower device in stock from Digikey was the ATMEGA169P. We used the 64 pin TQFP package for our review.
We took some quick images of some areas we think you will enjoy-
Delayering the device is one of the steps in analyzing any substrate. The part below was being delayered to remove it’s top two metal layers. The part is in-between Metal3 (M3) and Metal1 (M1) right now. Some of Metal2 (M2) has begun to remove. More time would finish off the removal of M2 but this was enough for us.
We are very familiar with the Atmel AVR line (to include the AT90SC smartcard family) and thus left it in the package not being concerned (there are various reasons to remove it completely out of the carrier it is bonded in which we won’t get into here).
The lower corner has the die identification (AT 355B6), Corporate logo, and the year.
It is our opinion that this processor is one of the most secure from the less-than 32 bit MCU off-the-shelf choices out there. There are debug test-points spread around the device (we would love to hear feedback from whoever thinks they see them hint hint) but don’t try to probe them if the device is locked. Atmel wised up around 2005 are turned those off if the lockbits are set (Hello Arne!).